PERCOBAAN-19 "MOTOR SERVO"

NAMA KELOMPOK :
1. M TAUFIQ IRVAN E. / 163600027
2. YULFI AINUN AL F. / 163600053

A)MENGGERAKKAN 1 MOTOR SERVO DENGAN ARDUINO

TUJUAN : Menggerakkan motor servo dengan sudut tertentu

PROGRAM :

#include <Servo.h> 
Servo servoku;
void setup()
{
servoku.attach(9); // pin out data servo terletak di pin 9 arduino
servoku.write(0); //mereset posisi servo ke posisi sudut 0 derajat
}
void loop()
{
}
 ================================================
Selanjutnya  masukkan program putaran servo dari posisi 0 ke 180 dan 180 ke 0
================================================
#include <Servo.h>

Servo myservo;  // create servo object to control a servo
// twelve servo objects can be created on most boards

int pos = 0;    // variable to store the servo position

void setup() {
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
}

void loop() {
  for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
    // in steps of 1 degree
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
  for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
}

B) MENGGERAKKAN 2 MOTOR SERVO DENGAN ARDUINO

TUJUAN :  " MENGGERAKKAN 2 MOTOR SERVO DARI SUDUT 90 DERAJAT - 180 DERAJAT"

PROGRAM :

#include <Servo.h>

Servo servo1,servo2;  // create servo object to control a servo
// twelve servo objects can be created on most boards
int pos = 0;    // variable to store the servo position
void setup() {
  servo1.attach(9);  // attaches the servo on pin 9 to the servo object
  servo2.attach(10);  // attaches the servo on pin 10 to the servo object
}

void loop() {
  for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
    // in steps of 1 degree
    servo1.write(pos);              // tell servo to go to position in variable 'pos'
    servo2.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
  for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
    servo1.write(pos);              // tell servo to go to position in variable 'pos'
    servo2.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
}